![]() ![]() The command is to get the firmware version. I've set up default values for the VISA Resource Name, assuming you have an alias set up in MAX for COM1. Thanks again!Accodring to the manual, checksum should be disabled by default. Thanks again for your help! I appreciate it! ![]() Is (Leading) the delimiter character and (Address)=AA, or are they something different and the delimiter character and AA are actually part of (Command)? On p.20 of the manual, it shows the Command Format as (Leading)(Address)(Command)(cr). The settings I'm using are the same as those mentioned in an earlier message (9600 Baud, 8 Bit, No parity, 1 stop, no flow) and an example of a code I used in the 'string to write' box (with Normal Display) is: $AAM(cr), with AA being 00, 01, 02, 03, etc., when I try to read the module name. ![]() I'm not sure if I'm entering the code incorrectly or if I have the wrong settings for the VISA Configure Serial Port. However, no matter what code I enter into the 'string to write' box, I still don't get an output in the 'read string' box and the 'bytes read' is always 0. I changed the 'termination char' input to 13 to signify a carriage return. It is a very helpful learning tool (considering there is no hard copy to be found in our lab). Thank you for the link to the user manual. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |